Create a Listener Policy

Follow this procedure to create a listener-policy, which is used by an egress to combine interfaces and perform post-processing actions.

About this task

Note the following naming conventions for name identifiers:

• The name cannot exceed 64 characters.
• The name must start with an alphabet character or an underscore.
• The name must contain alphanumeric characters and special characters (underscores, hyphens, or periods).
• The following reserved keywords cannot be used as name identifiers: all, ingress-group, egress, egress-group, match, list, access-list, route-map, and listener-policy.

Note

Sequence ID is required when you create a listener policy; it defines the order in which it is to be processed (see the Extreme 9920 Software Command Reference, 21.2.2.0 for more information).

1. Enter the Config mode.
   

   device(config)# 

2. Create a listener policy.
   

   device(config)# listener-policy lpl 10
   device(config-listener-policy)# match ip access-list v4_jumbo_traffic
   device(config-listener-policy)# truncate 512
   device(config-listener-policy)# end
   device#

3. Verify that the listener policy is created.
   

   device# show listener-policy lp1
   show listener-policy lpl
   listener-policy lpl 10
   forward-action permit
   match ip access-list v4_jumbo_traffic (pending)
   truncate 512
   Policy matches: 0  packets, 0  bytes, 0 Packets/sec, 0 Bits/sec